Quite often in buildings, both in apartments and private structures, you can see such a phenomenon as freezing walls. In this case, a procedure should be carried out that provides for wall insulation from the inside.
Most often, a “warm” plaster is used for this.
The use of “warm” plaster for insulation of surfaces
A layer of warm plaster is evenly applied to the plaster mesh, which ensures its strong adhesion. As a rule, the thickness of the layer should meet thirty millimeters.
It is advisable to carry out such a procedure for insulation of walls within the entire room and external plaster, the price of which is commensurate with the internal.
Only then will it be possible to stop the process of spreading dampness over the territory of the plastered site.
A very important point in this process is to ensure vapor barrier, which in the future will be able to protect the plaster from high humidity, which is located in the room. A layer of insulation material for walls is carried out on top of the plaster.
Before proceeding with the work on applying special plaster, it is necessary to clean the wall well of paint, wallpaper and old plaster. After that, it is necessary to carefully and reliably fix the reinforcing cage, which is made of a special mesh for plaster, to the wall.
Using a grid to hold the layer of applied plaster
At the moment, the greatest use in this type of work is found by a grid with cells no more than fifty millimeters.
When using the rails, the result is a gap between the wall and the grid, which allows you to very reliably hold the plaster layer.
For additional reliability, the grid must be pulled and beaten with nails every ten centimeters in a checkerboard or square order, leaving about two centimeters of the nail, which then bends to hold the grid sufficiently firmly hold.
When applying a plaster layer, the material is applied several times after the previous one.
As a result, after high -quality implementation of all procedures, the wall is obtained completely protected from the penetration of heat outward and cold inward.
Similar materials:
Depending on the constructive, as well as architectural directions and purpose, structural and technical parameters of various structures, for their construction may be used
The built house from the beam, over time, under the negative impact of atmospheric phenomena, is unusable, so it needs good protection from them.
Do -it -yourself hemp with your own hands is a rather painstaking business.
The grinding of a log house is one of the most important operations for decorating a wooden house.
